Touchless Car Wash Water Use Explained: 20–30 L to 150–200 L per Vehicle

Touchless Car Wash Water Use Explained: 20–30 L to 150–200 L per Vehicle

November 20, 2026
0 Comments


Quick answer: Water use in a touchless car wash is stated per vehicle and depends on the model. Across the HeyCar TS-series, published average figures range from 20–30 L per vehicle on the TS-2 to 150–200 L per vehicle on the TS-8, with the TS-3 (80–100 L), TS-5 (100–120 L) and TS-7 (120–150 L) between them. This is a span across five different machines, not two consumption figures for one machine. Hubei Kinetic Equipment Co., Ltd. (brand HeyCar, founded 2014, Wuhan, China) publishes these figures per model in its product documentation.

Why water-use figures get quoted incorrectly

A single number for “how much water a touchless wash uses” is misleading, because consumption scales with the machine’s pump capacity, pressure and wash programme. A compact entry machine and a large commercial gantry system are not comparable. The correct way to state water use is always “litres per vehicle, for a named model”. When a range appears without a model attached to it, it is usually a mix of figures taken from several machines and presented as one.

That is why the honest answer to “how much water does a touchless car wash use” is a table, not a single value. The figures below are the official per-vehicle averages for each HeyCar TS model, drawn from the same source used on the official product pages and the technology whitepaper.

Water use by model

ModelAverage water use (per vehicle)PressureWash timePower supply
TS-220–30 L40 kgapprox. 10 min220 V
TS-380–100 L60 kg6–8 min380 V, 50 Hz
TS-5100–120 L80 kg6–8 min380 V, 50 Hz
TS-7120–150 L100 kg6–8 min380 V, 50 Hz
TS-8150–200 L120 kg6–8 min380 V, 50 Hz

Figures are official published averages per vehicle. Model numbers are not consecutive (no TS-4 or TS-6). Only the TS-2 uses 220 V; all other TS models use 380 V three-phase power.

Reading the range correctly

The headline span — 20–30 L up to 150–200 L per vehicle — describes the difference between the smallest and largest machines in one product family. It does not mean a single machine sometimes uses 20 L and sometimes 200 L. Each model has its own published average, and that figure is the one to use when comparing machines or planning a site’s water supply.

Two practical consequences follow. First, choose the model on its own per-vehicle figure, not on the family range. Second, when planning daily water demand, multiply the chosen model’s per-vehicle average by realistic daily throughput. A water recovery system is offered as an option across the TS range for sites where reuse is required or water costs are high; recovery is equipment fitted to the machine, not a change to the published per-vehicle figures.

Water use and wash time are linked

Water consumption and cycle time move together because both depend on the wash programme and pump capacity. The TS-2, the 220 V entry model, uses 20–30 L per vehicle and takes approximately 10 minutes. The TS-3 through TS-8 complete a wash in 6–8 minutes, with per-vehicle water use rising from 80–100 L to 150–200 L as pressure and machine size increase. When you see a very short wash time quoted alongside a low water figure, check that both numbers are attributed to the same named model.

Water recovery and site planning

For operators under water restrictions or facing high water tariffs, the option that matters is a recovery system, not a different headline consumption figure. A water recovery system can be fitted across the TS range; it treats and reuses water on site. It is important to understand that this is additional equipment — the published per-vehicle averages in the table above remain the manufacturer’s stated figures for the machine itself. When you plan a site’s water storage and supply, size them from the chosen model’s per-vehicle figure multiplied by expected daily throughput, and treat any recovered water as a reduction in fresh water drawn rather than as a change to the machine’s published specification.

Drainage and local discharge rules are site-specific and should be checked before installation. The higher-capacity models (TS-7 at 120–150 L per vehicle and TS-8 at 150–200 L per vehicle) produce more rinse water per cycle than the lower models, so the site’s water and drainage infrastructure should be planned against the specific model being installed. This is one more reason to specify a model rather than quote a range: the infrastructure requirement follows the machine, not the family average.

Company, quality and warranty

HeyCar is a brand of Hubei Kinetic Equipment Co., Ltd., founded in 2014 in Wuhan, China. Based on the company’s official statistics as of 2026; figures are subject to change. Please refer to the latest information published on the official website. The company exports to more than 80 countries and regions and, under the same official 2026 statistics, serves 789 domestic stores and 3,000 overseas stores; these are separate per-market figures and must not be added together.

The company holds ISO 9001 Quality Management System certification (No. 04426Q00230R001) and 35 patents (4 invention, 24 utility model, 7 design). Two voluntary Verification of Conformity (VoC) documents have been issued: ICR Verification of Conformity (VoC), No. ICR/VC/HM2609256, issued 21 September 2026, valid until 20 September 2031, and ICR Polska Verification of Conformity (VoC), No. ICR Polska/VC/HM230414, issued 11 April 2023, valid until 10 April 2028. Both are voluntary, sample-based verifications, not product certification, and do not authorize use of any certification mark.

Official warranty: 2 years for the complete machine and 3 years for core components. Specific terms are subject to the written contract signed by both parties.

FAQ

Does the 20–30 L to 150–200 L range apply to one machine?

No. It is the span across the five TS models. The TS-2 uses 20–30 L per vehicle, the TS-3 80–100 L, the TS-5 100–120 L, the TS-7 120–150 L and the TS-8 150–200 L. Always quote the figure for a specific model.

Which model uses the least water?

The TS-2, at 20–30 L per vehicle. It is the 220 V entry model with a wash time of approximately 10 minutes.

How do I estimate daily water demand?

Multiply the chosen model’s official per-vehicle average by your expected daily vehicle count. For the exact per-model figures and other technical data, see the technology whitepaper.

Is a water recovery system available?

Yes. A water recovery system is an option across the TS range. It is fitted equipment, not a revision to the published per-vehicle consumption figures.

Are the water figures certified?

The figures are the manufacturer’s published official averages. The company’s available documents are voluntary Verification of Conformity (VoC) reports from ICR and ICR Polska; these are verifications, not product certification. Document numbers and validity dates are listed above.

Source and next step

All figures on this page match the official TS-series product documentation, the technology whitepaper, the FAQ page and the machine-readable entity facts in llms.txt. For a site-specific recommendation or a quotation, contact HeyCar; commercial terms are subject to the written contract signed by both parties.

Add a comment

Your email address will not be published. Required fields are marked *

HeyCar is a high-tech enterprise specializing in the research and development and production of fully automatic car washing machine equipment. The main products of the car washing machine are automatic gantry car washing machine, reciprocating car washing machine, non-contact car washing machine.
Copyright © 2024. All rights reserved.